PRODUCTS

Radcliff Wire routinely works with over 60 different metals to expertly produce standard and custom wire in a broad variety of shapes, sizes, and finishes.

Round-Shaped Wire

Copper Based Alloys
from .009″ to .162″ diameter
Stainless Steel Wire
from .015″ to .050″ diameter
(Only available with bright clean finish)

Square-Shaped Wire

Produced in All Alloys
from .015″ Square to .125″ Square
(Corner radii produced to customer’s requirements)

Rectangle-Shaped Wire

Produced in All Alloys
from .010 x .030″ to .070″ x .210″
Radcliff considers material with a 3:1 ratio or less rectangular.
(Corner radii produced to customer’s requirements)

Flat-Shaped Wire

Produced in All Alloys
from .005″ x .015″ to .062″ x .250″ or .093″ x .187″
Radcliff considers material with a 3:1 ratio or greater flat.
(Maximum wire width is .250”. As width is decreased, thickness may be increased.)

Half-Round-Shaped Wire

Produced in All Alloys
from .010″ x .020″ to .080″ x .160″
(Edge radius produced to customer’s requirements)

Available Edges


Square Edges	Rounded Corner	Natural Rolled or Round Edges	Full Rounded or Blended Edges
Flat side with very minimum radius at the corners.	Flat side with a larger specified radius on the corners.	No flat on side, slightly sharp corner where arc meets flats.	No flat on side. Arc blends into flats, eliminating sharp corners. Note: This edge available at slightly higher cost.

Available Finishes

We have the equipment and the experience to produce unique wire configurations that other companies can’t or don’t.

Some of our more common special shapes include:

Diamond-Shaped-Wire

Produced in All Alloys
from .013″ x .016″ to .135″ x .170″
(Exact radius and angles produced to customer requirements)

Triangle-Shaped-Wire

Produced in All Alloys
from .020″ to .170″
(Shaped to either equilateral or isosceles. Produced to customer requirements)

Keystone-Shaped-Wire

Produced in All Alloys
from .010″ x .020″ to .120″ x .170″
A quadrilateral shape having two parallel and two non-parallel sides.
(Produced to customer print design.)

House-Shaped-Wire

Produced in All Alloys
from .015″ x .020″ to .100″ x .140″
(Produced to customer print design)

Special-Shaped-Wire

Radcliff Wire can create tooling to produce special shaped wire to fill your unique requirement.
If you have a drawing, we can produce it!

Previously produced special shapes include:

Double D Wire

Convoluted Wire

Oval Shaped Wire

Arc Shaped Wire

Trapezoidal Wire

Channel Wire

V Groove Wire

Rail Shaped Wire

T-Shaped Wire

Wedge Shaped Wire

Gear Wire

Crescent shaped wire

Chamfered Wire

Angled Wire